Microchip Atmel-ICE Fejlfinding Udviklingssæt til SAM, AVR mikrokontrollere

Se alle Chip-programmeringsenheder

Indhold (1 enhed)*

Kr. 475,35

(ekskl. moms)

Kr. 594,19

(inkl. moms)

Add to Basket
Vælg eller skriv antal
På lager
  • 7 enhed(er) klar til afsendelse
Har du brug for mere? Indtast den mængde, du har brug for, og klik på "Tjek leveringsdatoer"
Enheder
Per stk.
1 +Kr. 475,35

*Vejledende pris

RS-varenummer:
130-6124
Producentens varenummer:
ATATMEL-ICE-PCBA
Brand:
Microchip
Find lignende produkter ved at vælge én eller flere attributter.
Vælg alle

Brand

Microchip

Undertype

Udviklingssæt

Produkttype

Fejlfinding

Til brug sammen med

SAM, AVR mikrokontrollere

Programmernavn

Atmel-ICE

Interfacetype

TPI, 1 Tråd, SPI, UPDI, JTAG, PDI, SWD

Standarder/godkendelser

No

ATATMEL-ICE PCBA


The Atmel-ICE series consists of development tools for debugging and programming ARM Cortex-M based Atmel SAM and Atmel AVR microcontrollers with on-chip debug capability. The Atmel-ICE series supports JTAG, SWD, PDI, TPI, aWire, SPI and debugWIRE interfaces and is compatible with Atmel Studio.

Kit Contains:


• Atmel-ICE unit without plastic encapsulation;130-6122 Full Kit available;130-6123 Basic Kit available

System Requirements


The Atmel-ICE unit requires that a front-end debugging environment Atmel Studio version 6.2 or later is installed on your computer. The Atmel-ICE should be connected to the host computer using the USB cable provided, or a certified Micro-USB cable.

How to turn the Atmel - ICE on?

The Atmel-ICE is powered by the USB bus voltage. It requires less than 100mA to operate, and can, therefore, be powered through a USB hub. The power LED will illuminate when the unit is plugged in. When not connected in an active programming or debugging session, the unit will enter low-power consumption mode to preserve your computer's battery. The Atmel-ICE cannot be powered down - it should be unplugged when not in use.

How does it connect?

The Atmel-ICE communicates primarily using a standard HID interface and does not require a special driver on the host computer. The Atmel-ICE must be connected to an available USB port on the host computer using the USB cable provided, or suitable USB certified micro cable. The Atmel-ICE contains a USB 2.0 compliant controller and can operate in both full-speed and high-speed modes. For best results, connect the Atmel-ICE directly to a USB 2.0 compliant high-speed hub on the host computer using the cable provided.

Sættype


Kabelsæt: 177-9591

Adaptersæt: 177-9590

Grundsæt: 130-6123

PCBA-sæt: 130-6124

Komplet sæt: 130-6122

Relaterede links