- RS-varenummer:
- 123-0922
- Brand:
- RS PRO
Dette produkt er udgået
Alternativ
- RS-varenummer:
- 123-0922
- Brand:
- RS PRO
Lovgivning og oprindelsesland
RoHS Status: Ikke relevant
- COO (Country of Origin):
- US
Generel produktinformation
RS Pro sæt med justerbare parallelklodser
RS Pro sæt med justerbare parallelklodser, bruges til kontrol, mærkning eller placering af arbejdsemner. Består af to præcisionsslebne stykker, som kan glide helt gnidningsløst mod hinanden.
Egenskaber og fordele
Parallelklodser består af 2 dele, der er sat sammen
Låses på plads med sætskruer
Kan indstilles til en mikrometer i størrelse
Låses på plads med sætskruer
Kan indstilles til en mikrometer i størrelse
Specifikation
Sæt med 6 parallelklodser 3/8 tommer-2 1/4 tommer (9,5 - 57,2 mm)
Leveres med
Vinyletui
Parallels, Surface Finish & Hardness
Surface Finish
Any machined component has a surface geometry which consists of three basic elements:
Form or Curvature - Whether the surface has irregular bumps or dimensional changes
Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)
Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)
Waviness - Whether the surface has regular repetitive ripples or patterns (e.g. milling patterns)
Roughness - The shapes or irregularities that are smaller than, and form part of the waviness pattern (e.g. material micro-structure)
Waviness and roughness are traditionally the most difficult elements to measure when comparing surface finish, however, they have a radical effect on the performance of the finished component. Variations will cause aesthetic appearance changes, component wear variations, oil retention variation etc. Many manufacturers therefore specify a range of roughness values which their components should be manufactured to, often expressed as: Ra, Rq (RMS), RzDIN, Ry, Sm,mm.